Print The Porto

A collection of tips about 3d printing.

September 2016

Posts 1 to 2 of 2

How to save a print that is losing supports

I was recently reading though the 3D Printing group on facebook when one of the members, Ken Jones, posted an amazing trick to save a print when the support structure falls off. Just use putty or clay to hold it in place. … View More

How to calibrate your 3d printer for accurate printing

Most people don't realize it, but you can get reasonably accurate prints with just about any 3D Printer, even with low-end clones. With a little bit of time and measuring, prints can be within .05mm accuracy. Having an uneven X and Y is where a 20mm cube will print 20.5mm on the X-axis and 19.95mm on the Y-Axis and cause circles to be over or under-sized and eleptical. Most machines will come with preset steps configured, based off of… View More